Overview
Dulux Trade Vinyl Silk is a quality washable paint with a tough finish. It is for use on normal walls and ceilings. Use Eggshell on areas prone to condensation or exposed to water. Excellent coverage of up to 16m2 per litre. Modern, mid-sheen silky finish.
- Re-coatable in 2-4 hours
- Washable & tough
- Mid-sheen finish
Area | Interior |
Recommended Use | Normal interior walls and ceilings where a mid sheen finish is required |
Base | Water-Based |
Coverage | Up to 16m² per litre |
Drying Time | 2-4 Hours |
Re-Coat Time | 2-4 Hours |
Recommended Coats | 2-3 Coats |
Application Method | Brush, Roller, Conventional Spray, Airless Spray |
VOC Levels | Low |
Clean Up | Remove as much paint as possible from the equipment before cleaning with water |
Preparation
Ensure that surfaces to be painted are sound, clean and dry. New surfaces in particular must be fully dry.
- Remove all loose and defective paint. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.
- Where necessary, wash the surface to remove dirt, grease and powdery or dusty residues. Rinse with clean water and allow to dry.
- Seal surfaces that remain powdery after thorough preparation with an appropriate .
- Where necessary, rub down and then wipe off with a damp, lint free cloth to avoid dust.
Application
Always follow the manufacturers instructions found on the tin, it is recommended that a small test area is applied before painting the entire surface to ensure compatibility.
- To reduce the risk of picture framing or a patch finish, it is important to stir the paint thoroughly before use.
- Seal new or bare surfaces with a thinned first coat of Dulux Trade Vinyl Silk (up to 1 part clean water to 5 parts paint).
- Two coats are generally required, however additional coats may be necessary when colour change is significant
- If thinned, the paint used for cutting-in and for rolling should be to the same ratio.
- Cut in one wall at a time, rolling immediately afterwards. Do not allow the cutting-in to dry before rolling.
- Cut in no more than 5 to 8cm away from any internal angles, including sockets, switches, skirting, architraves etc. Roll into the cutting-in, ensuring you roll as close to the edge as possible.